Replacing the ServeRAID adapter memory module

Use this information to replace the ServeRAID adapter memory module.

To install the ServeRAID adapter memory module, complete the following steps:

1. Read the safety information that begins on Safety and Installation guidelines.
2. Turn off the server and peripheral devices and disconnect all power cords.
3. Remove the cover (see Removing the cover).
4. Remove the ServeRAID SAS/SATA controller (see Removing a ServeRAID SAS/SATA controller).
5. Align the memory module with the connector on the ServeRAID adapter and push it into the connector until it is firmly seated.
   Figure 1. ServeRAID memory module installation
   
   
6. Reinstall the ServeRAID SAS/SATA controller (see Replacing a ServeRAID SAS/SATA controller).
7. Reconnect the power cords and any cables that you removed.
8. Reinstall the cover (see Replacing the cover).
9. Slide the server into the rack.
10. Turn on the peripheral devices and the server.