Replacing a ServeRAID SAS/SATA controller

Use this information to replace a ServeRAID SAS/SATA controller.

1. Read the safety information that begins on Safety and Installation guidelines.
2. Turn off the server and peripheral devices and disconnect all power cords.
3. Remove the cover (see Removing the cover).
4. Remove PCI riser-card assembly 1 if necessary (see Removing a PCI riser-card assembly).
5. If you are installing a new or replacement SAS/SATA adapter, touch the static-protective package that contains the new SAS/SATA adapter to any unpainted metal surface on the server. Then, remove the new SAS/SATA adapter from the package.
6. Align the SAS/SATA adapter so that the keys align correctly with the connector on the system board.
7. Insert the SAS/SATA adapter in the dedicated connector on the system board or PCI riser-card slots.
   Attention

   Incomplete insertion might cause damage to the server or the adapter.
   1. Insert the SAS/SATA adapter into the RAID connector on the system board until it is firmly seated. The retention brackets secure the SAS/SATA adapter in place when the adapter is firmly seated into the connector.
      Note

      Remove the PCI bracket that come with ServeRAID H1110, ServeRAID M1115, or ServeRAID M5110 SAS/SATA adapter before installing a SAS/SATA adapter in the dedicated connector on the system board.

      Figure 1. ServeRAID adapter installation
      
      
   2. Insert the SAS/SATA adapter into the PCI riser cards (see Replacing an adapter).
      Figure 2. Adapter installation
      
      
8. Route the backplane signal cables (see Cabling backplane).
   Figure 3. ServeRAID adapter cable routing
   
   
9. Connect the signal cables to the SAS/SATA adapter:
   1. ServeRAID H1110 adapter: Take the signal cable that is attached to the drive backplane for drive bays 0 through 3 and connect it to the SAS/SATA connector on the ServeRAID adapter.
      Figure 4. ServeRAID H1110 adapter cable routing
      
      
   2. ServeRAID M1115 adapter: Take the signal cable that is attached to the drive backplane for drive bays 4 through 7 and connect it to the ServeRAID adapter connector for drive bays 4 through 7 (port 1). Connect the other signal cable that is attached to the drive backplane for drive bays 0 through 3 and connect it to the other connector (port 0) on the adapter.
      Figure 5. ServeRAID M1115 adapter cable routing
      
      
   3. ServeRAID M5110 adapter: Take the signal cable that is attached to the drive backplane for drive bays 4 through 7 and connect it to the ServeRAID adapter connector for drive bays 4 through 7 (port 1). Connect the other signal cable that is attached to the drive backplane for drive bays 0 through 3 and connect it to the other connector (port 0) on the adapter.
      Figure 6. ServeRAID M5110 adapter cable routing
      
      
10. Reconnect the power cords and any cables that you removed.
11. Replace PCI riser-card assembly 1 if you have removed it earlier (see Replacing a PCI riser-card assembly).
12. Replace the cover (see Replacing the cover).
13. Turn on the peripheral devices and the server.