Removing the front USB connector assembly

To remove the front USB connector assembly that is on the side of the server, complete the following steps:

1. Read the safety information that begins on page Safety and Installation guidelines.
2. Turn off the server (see Turning off the server) and all attached peripheral devices. Disconnect all power cords; then, disconnect all external cables as necessary to replace the device.
3. Remove the screws from the cable arm cover; then, slide the cable arm cover towards the rear of the server and set it aside.
   Figure 1. Screw removal
   
   
4. Remove the screws that secure the front USB connector assembly to the side of the server.
5. Disconnect the cable to the front USB connector assembly.
   Figure 2. Front USB connector assembly removal
   
   
6. If you are instructed to return the front USB connector assembly, follow all packaging instructions, and use any packaging materials for shipping that are supplied to you.