Removing a USB embedded hypervisor flash device

Use this information to remove a USB embedded hypervisor flash device.

1. Read the safety information that begins on page Safety and Installation guidelines.
2. Turn off the server (see Turning off the server) and all attached peripheral devices. Disconnect all power cords; then, disconnect all external cables as necessary to replace the device.
3. Remove the server top cover (see Removing the server top cover).
4. Rotate the hot-swap rear hard disk drive cage up (see Rotating the hot-swap rear hard disk drive cage up.
5. Remove PCI riser-card assembly 1 (see Removing a PCI riser-card assembly).
6. Locate the USB embedded hypervisor flash device connector on the system board.
   Figure 1. USB embedded hypervisor flash device connector
   
   
7. Slide the lockbar on the flash device connector to the unlocked position and pull the USB flash device out of the connector.
   Figure 2. USB embedded hypervisor flash device removal
   
   
8. If you are instructed to return the hypervisor memory key, follow all packaging instructions, and use any packaging materials for shipping that are supplied to you.
   Note

   You must configure the server not to look for the hypervisor USB drive. See Configuring the server for information about disabling hypervisor support.