Replacing the insulator sheet for the power cable

Use this information to replace the insulator sheet for the power cable

1. Read the safety information that begins on page Safety and Installation guidelines.
2. Turn off the server (see Turning off the server) and all attached peripheral devices. Disconnect all power cords; then, disconnect all external cables as necessary to replace the device.
3. Remove the server top cover (see Removing the server top cover).
4. Rotate the hot-swap rear hard disk drive cage up (SeeRotating the hot-swap rear hard disk drive cage up).
5. Remove the liner from the insulator sheet.
   Figure 1. Liner removal
   
   
6. Align the insulator sheet with the bracket on the right side and insert it to the slot straight.
   Figure 2. Insulator sheet
   
   
7. Use you fingers to press the bottom of the insulator sheet back and forth and make sure it is fixed correctly.