Replacing the front USB connector assembly

To install the front USB connector assembly that is on this side of the server, complete the following steps:

1. Read the safety information that begins on page Safety and Installation guidelines
2. Touch the static-protective package that contains the front USB connector assembly to any unpainted metal surface on the outside of the chassis; then, remove the front USB connector assembly from the package.
3. Reconnect the cable to the front USB connector assembly.
   Figure 1. Front USB connector assembly installation
   
   
4. Install the screws to secure the front USB connector assembly to the side of the server.
5. Install the screws to secure the cable arm cover to the server.
   Note

   The cable is routed on the outside of the chassis and connected to the USB connector board. The cable must be protected by the cable cover on the side of the chassis.
6. Install the server top cover (see Replacing the server top cover).
7. Reconnect the external cables; then, reconnect the power cords and turn on the peripheral devices and the server.