Skip to main content

Removing a memory module

Use this information to remove a memory module.

To remove a dual inline memory module (DIMM), complete the following steps:

  1. Read the safety information that begins on page Safety and Installation guidelines.
  2. Turn off the server (see Turning off the server) and all attached peripheral devices. Disconnect all power cords; then, disconnect all external cables as necessary to replace the device.
  3. Remove the server top cover (see Removing the server top cover).
  4. Rotate the hot-swap rear hard disk drive cage up (see Rotating the hot-swap rear hard disk drive cage up).
  5. Remove the PCI riser-card assembly (see Removing a PCI riser-card assembly).
  6. Remove the air baffle (see Removing the air baffle).
  7. Carefully flip open the retaining clip on each end of the DIMM connector and lift the DIMM from the connector.
    Attention
    To avoid breaking the retaining clips or damaging the DIMM connectors, open and close the clips gently.
    Figure 1. DIMM removal
    DIMM removal
  8. If you are instructed to return the DIMM, follow all packaging instructions, and use any packaging materials for shipping that are supplied to you.