Removing the insulator sheet for the power cable

Use this information to remove the insulator sheet for the power cable

To remove the insulator sheet for the power cable, complete the following steps.

1. Read the safety information that begins on page Safety and Installation guidelines.
2. Turn off the server (see Turning off the server) and all attached peripheral devices. Disconnect all power cords; then, disconnect all external cables as necessary to replace the device.
3. Remove the server top cover (see Removing the server top cover).
4. Rotate the hot-swap rear hard disk drive cage up (See Rotating the hot-swap rear hard disk drive cage up).
5. Remove the insulator sheet from the server.
   Figure 1. Insulator sheet removal