Skip to main content

Replacing the front USB and video connector assembly inside media cage

Use this information to replace the front USB and video connector assembly inside media cage.

Note
The server configuration you have bought may either have the front USB connector assembly inside the media cage or on the side of the server.

To install the front USB and video connector assembly that is inside the media cage, complete the following steps:

  1. Read the safety information that begins in Safety and Installation guidelines.
  2. Install the front USB connector assembly (see Replacing the front USB connector assembly) and the front video connector (seeReplacing the front video connector) to the front USB and video connector assembly.
  3. Slide the front USB and video connector assembly into the media cage until it clicks into place.

  4. Carefully push the media cage back into the server.

  5. Tighten the thumbscrew to secure the media cage onto the server.

  6. Reconnect the USB, video, CD/DVD and operator information cables to the system board. Remember to insert the cables into the relevant cable clips and cable tie.



  7. Install the air baffle (see Replacing the air baffle).
  8. Install the PCI riser-card assembly (see Replacing a PCI riser-card assembly).
  9. Install the server top cover (see Replacing the server top cover).
  10. Reconnect the power cord and any cables that you removed.
  11. Turn on the peripheral devices and the server.