Skip to main content

Replacing the front video connector

Use this information to replace the front video connector.

To replace the front video connector, complete the following steps:

  1. Read the safety information that begins in Safety and Installation guidelines.
  2. Align the video connector with the slot on the front USB and video connector assembly.

  3. Install the two screws to secure the video connector to the front USB and video connector assembly.

  4. Slide the front USB and video connector assembly into the media cage until it clicks into place.

  5. Carefully push the media cage back into the server.


  6. Tighten the thumbscrew to secure the media cage onto the server.

  7. Reconnect the USB, video, CD/DVD and operator information cables to the system board. Remember to insert the cables into the relevant cable clips and cable tie.




  8. Install the air baffle (see Replacing the air baffle).
  9. Install the PCI riser-card assembly (see Replacing a PCI riser-card assembly).
  10. Install the server top cover (see Replacing the server top cover).
  11. Reconnect the power cord and any cables that you removed.
  12. Turn on the peripheral devices and the server.