Skip to main content

Removing an ML2 (Ethernet) adapter

Use this information for instructions on how to remove an ML2 (Ethernet) adapter.

To remove an ML2 (Ethernet) adapter, complete the following steps:

  1. Before you begin, read Safety and Installation guidelines .
  2. Turn off the server (see Turning off the server) and all attached peripheral devices. Disconnect all power cords; then, disconnect all external cables as necessary to replace the device.
  3. Remove the standard I/O book from the server (see Removing the standard I/O book).
  4. Open the adapter retention lever.
  5. Carefully grasp the adapter and pull it out of the connector on the standard I/O book board.
  6. If you are instructed to return the adapter, follow all packaging instructions, and use any packaging materials for shipping that are supplied to you.