Skip to main content

Replacing a USB embedded hypervisor flash device

Use this information for instructions on how to replace a USB hypervisor flash device.

The internal USB hypervisor flash device connector is on the standard I/O book (see Standard I/O book for the location of the connector). To install a USB hypervisor flash device, complete the following steps:

  1. Align the USB flash device with the connector on the standard I/O book board and push it into the connector until it is firmly seated.
  2. Slide the lockbar up to the locked position until the lockbar is firmly seated. Rotate the air baffle down if rotated it up earlier.

    Illustration of replacing the USB flash device
  3. Reinstall the standard I/O book in the server (see Replacing the standard I/O book).
  4. Reconnect the power cord and any cables that you removed.
  5. Turn on the peripheral devices and turn on the server.