Skip to main content

Replacing a RAID adapter flash power module in the storage book

Use this information for instructions on how to replace a RAID flash power module in the storage book.

Note
  • You can install up to two RAID flash power modules in the storage book.

When you install multiple RAID adapters in the storage book and they come with flash power modules, install flash power modules in the slots inside the storage book. To install a RAID adapter flash power module in the storage book, complete the following steps:

  1. Open the retention clip on the flash power module slot. Press the blue tab outward to open the retention clip.
  2. Rotate the retention clip all the way up.
  3. Place the flash power module in the flash power module slot with the cable at the bottom and facing the rear of the storage book.
  4. Connect the flash power module cable to the adapter.
  5. Rotate the retention clip down and press it until it clicks in place.
  6. Reconnect the cables to the drive backplane.
  7. Reinstall the storage book in the server.
  8. Reconnect the power cord and any cables that you removed.
  9. Turn on the peripheral devices and turn on the server.