Removing a USB embedded hypervisor flash device

Use this information for instructions on how to remove a USB hypervisor flash device.

To remove a USB embedded hypervisor flash device, complete the following steps:

1. Before you begin, read Safety and Installation guidelines .
2. Turn off the server (see Turning off the server) and all attached peripheral devices. Disconnect all power cords; then, disconnect all external cables as necessary to replace the device.
3. Remove the standard I/O book from the server (see Removing the standard I/O book).
4. Locate the USB embedded hypervisor flash device connector on the standard I/O book board (see Standard I/O book for the location of the connector).
   Note

   You can rotate the standard I/O book air baffle up, if needed, to access the USB flash device connector.
5. Slide the lockbar on the USB flash device connector down to the unlocked position and pull the USB flash device out of the connector.
   
   
   
6. If you are instructed to return the USB flash device, follow all packaging instructions, and use any packaging materials for shipping that are supplied to you.